Reading Crane Master Body and Vmac

Here is a job we just finished! It is a Reading Crane Master Body. We also installed a work bench bumper, Palfinger Crane PSC 3216 Crane, work bench bumper, manual out-riggers, Vmac G30 air compressor, auxiliary work lighting, drawer unit, and a few hose and welding cable reels.

Here is a view of the driver's side showing the location of the Vmac G30 Rotory screw air compressor(top left), Ctech drawer unit(bottom left), welding reels(top center), and the rear hose reel/air regulator(right). 

The Vmac G30 is a rotory screw air compressor that is capable of producing 30CFM at 100psi. This compressor has optional triple 4 gallon tanks which gives a total of 12 gallons. The tanks are nice for some extra burst capacity but the G30 will still produce 30CFM at 100psi with a 100% duty cycle!

The Reelcraft cable reels are mounted half way down the body. One reel is a grounding cable and the other reel supplies a welding lead. Each reel is capable of reaching 50ft.  The customer has a used welder that they are planning to install behind these reels. 

The hose reel is located in the top of the rear driver's side compartment. The filter/water separator/regulator/lubricator is located just beneath the reel. The reel empties out on the back of the body were it can easily be pulled out up to 25ft.  

The workbench bumper is not only a bumper that provides a flat surface, it also has internal storage for longer tools. This customer had a large piece of machinery that they were wanting to pull so we reinforce this hitch to handle his load!  

Here's view of the Palfinger Crane PSC 3216 Crane. This Crane is electric over hydraulic and has a 3200lbs capacity. It is power up/down, in/out, angle, and rotation. The remote is wireless push button(show in the pic on the right). This is a very smooth running crane! 

As always, thanks for checking out the post!